Replace Missing Values

In this example, the variables SES and URBANICITY are class variables for which the value ? denotes a missing value. Because a question mark does not denote a missing value in the terms that SAS defines a missing value (that is, a blank or a period), SAS Enterprise Miner sees it as an additional level of a class variable. However, the knowledge that these values are missing will be useful later in the model-building process.

To use the Replacement node to interactively specify that such observations of these variables are missing:

Select the Modify tab on the Toolbar.
Select the Replacement node icon. Drag the node into the Diagram Workspace.
Connect the Data Partition node to the Replacement node.
Select the Replacement node. In the Properties Panel, scroll down to view the Train properties.
1. For interval variables, click on the value of Default Limits Method, and select None from the drop-down menu that appears. This selection indicates that no values of interval variables should be replaced. With the default selection, a particular range for the values of each interval variable would have been enforced. In this example, you do not want to enforce such a range.
  
  Note: In this data set, all missing interval variable values are correctly coded as SAS missing values (a blank or a period).
2. For class variables, click on the ellipses that represent the value of Replacement Editor. The Replacement Editor opens.
  
  Notice that SES and URBANICITY both have a level that contains observations with the value ?. In the case of these two variables, this level represents observations with missing values. Enter _MISSING_ as the Replacement Value for the two rows, as shown in the image below. This action enables SAS Enterprise Miner to see that the question marks indicate missing values for these two variables. Later, you will impute values for observations with missing values.
  
  Enter _UNKNOWN_ as the Replacement Value for the level of DONOR_GENDER that has the value A. This value is the result of a data entry error, and you do not know whether the intention was to code it as an F or an M.
  
  Click OK.
In the Diagram Workspace, right-click the Replacement node, and select Run from the resulting menu. Click Yes in the Confirmation window that opens.
In the window that appears when processing completes, click OK.

Note: In the data that is exported from the Replacement node, a new variable is created for each variable that is replaced (in this example, SES, URBANICITY, and DONOR_GENDER). The original variable is not overwritten. Instead, the new variable has the same name as the original variable but is prefaced with REP_. The original version of each variable also exists in the exported data and has the role Rejected.

Tip

To view the data that is exported by a node, click the ellipses that represent the value of the General property Exported Data in the Properties Panel. To view the exported variables, click Properties in the window that opens, and then view the Variables tab. Similarly, you can view the data that is imported and used by a node by clicking the ellipses that represent the value of the General property Imported Data in the Properties Panel.