Adding Attachments to Frame Controls

Introduction

Attachments are connections between two or more components on a frame. These connections can control the placement and size of components. Component placement and size may be affected by attachments when a component is resized or moved, or when the component's frame is resized.

Attachments remain valid even if automatic component resizing becomes necessary. Automatic component resizing occurs when you resize either components themselves or the frame on which your components exist.

This appendix provides detailed information on setting attachments, as well as useful attachment tips.

Note: In previous versions of SAS/AF software, each component was surrounded by an area known as a region. Components and regions are no longer separated or regarded as two separate areas. In most cases, the term region is synonymous with component. [cautionend]

Top of Page